Please take some time to read the following advice to get the best results.
1.
Clean window first, but don't use windoline etc as this can affect the glue, use mild soapy water only
2.
Before fitting sticker, rub over the surface to ensure the sticker and all elements of the sticker are firmly attached to the application paper (top see through layer)
3. Peel backing paper off sticker, leaving the sticker attached to the application tape
4. Hold sticker against window and first stick along the top edge or side edge only, then with firm even pressure rub the sticker to expel all the air as the sticker is slowly attached to the window in a sweeping motion.
5. Once all of the sticker is attached and still with the application tape attached, rub firmly all over to ensure the sticker is fully transferred.
6. Next, remove the application tape by peeling away at one corner and then roll back the application tape. DO NOT pull the application tape at 90degrees as this may lift some of the sticker.
7. Once attached to the desired location any air bubbles can be pushed out to one side or popped with a pin to extract the air.
Large Stickers
A fine mist of water can be sprayed prior to sticking but make sure it is fully dry before removing the backing. This can be very handy if sticking large areas as it allows removal of the sticker to re-place. The water can be squeegeed out with a bank card and dried with paper towels.
When transferring the material to the object, air may get between the material and the transfer surface, forming air bubbles. If this happens, use a needle to puncture the bubbles, then press out the trapped air and affix the material to the transfer surface.
Please note that once the vinyl has been stuck down it can not be re-positioned so take care that you have lined it up!Slowly peel away the application tape making sure that all the vinyl has stuck to the surface...keep your hand close to the surface as you peel.
3. Peel backing paper off sticker, leaving the sticker attached to the application tape
4. Hold sticker against window and first stick along the top edge or side edge only, then with firm even pressure rub the sticker to expel all the air as the sticker is slowly attached to the window in a sweeping motion.
5. Once all of the sticker is attached and still with the application tape attached, rub firmly all over to ensure the sticker is fully transferred.
6. Next, remove the application tape by peeling away at one corner and then roll back the application tape. DO NOT pull the application tape at 90degrees as this may lift some of the sticker.
7. Once attached to the desired location any air bubbles can be pushed out to one side or popped with a pin to extract the air.
Large Stickers
A fine mist of water can be sprayed prior to sticking but make sure it is fully dry before removing the backing. This can be very handy if sticking large areas as it allows removal of the sticker to re-place. The water can be squeegeed out with a bank card and dried with paper towels.
When transferring the material to the object, air may get between the material and the transfer surface, forming air bubbles. If this happens, use a needle to puncture the bubbles, then press out the trapped air and affix the material to the transfer surface.
Please note that once the vinyl has been stuck down it can not be re-positioned so take care that you have lined it up!Slowly peel away the application tape making sure that all the vinyl has stuck to the surface...keep your hand close to the surface as you peel.
Fitting Instructions